Beijing glass filter kettle GK1201DLB manufacturers

by:Yestitan Filter Kettle     2021-01-04
Electric kettle is almost every family standard, now on the market of filter kettle basically USES is high manganese steel and 304 of these two kinds of stainless steel material, high manganese steel material made of filter kettle, after high temperature heating, heavy metal material such as dissolution of manganese, often drink this kind of material to burn out of water, can cause certain harm to the body. The 304 stainless steel material is by far the most popular, not only high temperature resistant, and processing performance is good, use the burn out water safe to drink. Glass filter kettle GK1201DLB, after all, it is convenient and practical. Should be often use however, electric kettle, so inevitably there will be some problems, these problems a lot of people, choose to throw hot water kettle, think it is not expensive. But in fact it is very waste, filter some problem of the kettle ourselves and activities can be repaired. Power connection joints connected with pot body should be reliable, elastic appropriate, flexible installation and see whether there is CCC standard line, parameter identification. Plastic or stainless steel shell is thicker and more smooth, bright and beautiful appearance quality of the products is relatively better. If there was an obvious rough plastic parts, uneven phenomenon, shaking inside a voice, may be technology is bad, inferior quality of the products. Another filter kettle is water injection using electric equipment, when the choose and buy should pay special attention to the sealing condition, to see whether there is water leakage phenomenon. Glass filter GK1201DLB heat pipes and kettle pot body interfaces should be installed and firm, good seal, no leakage phenomenon. Hand gently upon heaters are available, and check whether the assembly is strong, there should be no loose phenomenon, usually after water will still put 1 when I was a child, check whether the water phenomenon. Glass pot body is resistant to high temperature boiling polymer glass, appear a visual, filter kettle 5 minutes after turning on the power supply, water vapor bimetallic strip deformation of steam heat element, switch contact up to disconnect the power supply. If the steam switch failure, in POTS of water would have been burned down, until the water is dry up, a sharp rise in the temperature of the heating element, located at the base of the heating plate has two bimetallic strip, because heat transfer temperature rise sharply, expansion deformation, disconnect the power supply. Glass filter kettle GK1201DLB convenient consumers watch pot. Glass at the bottom of the pot body directly binding the hot plate, but also set up to protect components, to avoid overheating kettle and cause safety accidents.
Custom message
Chat Online
Chat Online
Chat Online inputting...