water filter pitcher

Beijing glass filter kettle GK2007CT advisory telephone

by:Yestitan Filter Kettle     2021-01-07
Pot body adopts handblown, and the high borosilicate glass, in POTS heating plate for medical grade 316 stainless steel, compared to most of the 304 stainless steel material on the market, not only the heat stability, strong corrosion resistance. Plastic or stainless steel shell is thicker and more smooth, bright and beautiful appearance quality of the products is relatively better. If there was an obvious rough plastic parts, uneven phenomenon, shaking inside a voice, may be technology is bad, inferior quality of the products. Another filter kettle is water injection using electric equipment, when the choose and buy should pay special attention to the sealing condition, to see whether there is water leakage phenomenon. Glass filter GK2007CT even close contact with the tea kettle, also fear harmful substances precipitation, boil tea using double rest assured. Power connection joints connected with pot body should be reliable, elastic appropriate, flexible installation and see whether there is CCC standard line, parameter identification. An electric kettle is heated by heating chassis. Electric welding chassis and bottom together. Pot bottom side located in POTS, and heating the chassis and the conductive terminals are placed in a pot, inside and outside to bolt fastening, on liner in all electric heat pipe and the pot body between the implementation of synthetic sealing and leakage. Although the o-ring seal has above 100 ℃ high temperature resistant performance. Glass filter GK2007CT heat pipes and kettle pot body interfaces should be installed and firm, good seal, no leakage phenomenon. Hand gently upon heaters are available, and check whether the assembly is strong, there should be no loose phenomenon, usually after water will still put 1 when I was a child, check whether the water phenomenon. Glass electric kettle using the latest coupler structure, safe and durable. Filter kettle 5 minutes after turning on the power supply, water vapor bimetallic strip deformation of steam heat element, switch contact up to disconnect the power supply. If the steam switch failure, in POTS of water would have been burned down, until the water is dry up, a sharp rise in the temperature of the heating element, located at the base of the heating plate has two bimetallic strip, because heat transfer temperature rise sharply, expansion deformation, disconnect the power supply. Glass filter kettle GK2007CT it USES conductive ring is 360 degrees, can conduct electricity work is put at any Angle, has the function of manual and automatic; Use double micro pressure switch, silver contact when too little water in the kettle is lower than the lowest water level or when there is no water in your pot, kettle automatically power off, prevent dry; When you take the kettle.
Custom message
Chat Online
Chat Online
Chat Online inputting...