With the improvement of modern people life quality, filter the kettle has become a necessary equipment of home appliances, small pot supporting the family drinking water problems.
People drink 8 glasses of water a day is normal, so the family how much water to drink?
A family an electric kettle is used how many times a day?
May everyone is self-evident.
Indeed, filter kettle easy bad is not the pot body, more not the tank, filter kettle easy bad is the thermostat.
The thermostat is broken mean that the whole filter termination of service life of the kettle?
The answer is no.
Today, I will tell you that you install the filter kettle switch circuit knowledge.
Filter kettle dry controller principle here the so-called filter kettle dry combustion controller is temperature control switch.
Kettle 5 minutes after turning on the power supply, water temperature gradually rises to 100 degrees, the water begins to boil, steam impact switch on bimetallic above, under the action of thermal shrinkage, double metal expansion deformation, press the switch contact to cut off the power supply.
If the steam switch failure, the pot of water will dry up until dry, heating element temperature rise sharply, there are two double metal plate at the bottom of the heating plate, due to the heat transfer temperature rise sharply, expansion deformation, disconnect the power supply.
Therefore, the filter of the kettle is very scientific and reliable safety protection device.
This is the filter kettle triple the principle of security and protection.
The method of filter installation kettle switch: electric hot water pot as spring reset switch, bimetallic strip, contact switch, open the key, and so on several parts.
The installation time, bimetallic strip and switch fulcrum for good, and then put the spring ring, hook in the front of another switch seats should be toward the switch.
No open side ahead, hanging on the hook before the switch button.
Then press the button to try, if feel elastic, can remain open, can shut down basic status, and boiling water try, see if after boiling water will jump, if after boiling water 1 - can't jump
For 2 minutes, bimetallic strip is in the right position, reinstall.