After electrify indicator, but there was no hot water and sometimes filter electric kettle was found after the indicator light is lit, but no water in the heating, hot water bottle and no movement, this kind of situation mostly because the faults or electric heating tube link.
When using electric kettle, must hold water, after electrify, avoid by all means to electricity, water, after fill in POTS should be at least the lowest water level, but not more than the highest water level regulation.
An electric kettle boil with acid, alkali, salt composition, in order to avoid the pot body and heater, eroded.
But also often remove the scale on the electric heater or other besmirch, otherwise it will affect the thermal efficiency of heater and service life.
Glass filter kettle GK2007AT solution: open hot water switch box, look at the internal metal shrapnel deformation, with or without corrosion, and then make a decision whether to replace.
Glass electric kettle using the latest thermostat structure, safe and durable.
Now on the market of filter kettle basically USES is high manganese steel and 304 of these two kinds of stainless steel material, high manganese steel material made of filter kettle, after high temperature heating, heavy metal material such as dissolution of manganese, often drink this kind of material to burn out of water, can cause certain harm to the body.
The 304 stainless steel material is by far the most popular, not only high temperature resistant, and processing performance is good, use the burn out water safe to drink.
Glass filter kettle GK2007AT it USES conductive ring is 360 degrees, arbitrary Angle put can electricity work, has the function of manual and automatic;
Use double micro pressure switch, silver contact when too little water in the kettle is lower than the lowest water level or when there is no water in your pot, kettle automatically power off, prevent dry;
You don't have to worry about whether have also cut off power supply.
Electric kettle is a household name, it is convenient to use and safety performance is high, the electric kettle is heated by heating chassis.
Electric welding chassis and bottom together.
Pot bottom side located in POTS, and heating the chassis and the conductive terminals are placed in a pot, inside and outside to bolt fastening, on liner in all electric heat pipe and the pot body between the implementation of synthetic sealing and leakage.
Although the o-ring seal has above 100 ℃ high temperature resistant performance.
Glass filter kettle GK2007AT so has long been favored by consumers.
Now not only pay attention to practical, electric kettle and appearance also let consumers to feast for the eyes, relieve fatigue of consumer visual can promote better sales.